Add a function `ParseFixedPoint` that parses numbers according
to the JSON number specification and returns a 64-bit integer.
Then this in `AmountFromValue`, rather than `ParseMoney`.
Also add lots of tests (thanks to @jonasschnelli for some of them).
Fixes issue #6297.
In txn_clone.py, non-essential test transaction tx2 was asserted
to be unconfirmed, but would occasionally confirm depending on
network behavior. Fix by explicitly sharing with miner and
checking for 1 confirmation.
Reduce required conflict tests from 4 to 2, by moving one invocation
each of txn_clone.py and txn_doublespend.py to the extented test
section. This saves about 15 seconds per test run for me.
This allows users to specify, e.g. raise, the default timeout of 60
seconds. Some bitcoind instances, especially long running ones on slow
hardware, require a higher timeout for a clean shut down.
Also add a comment to bitcoind.openrc's 'retry=', since it is not
obvious from the variable name what it does.
Four cases included:
* The CLTV operand type mismatches the tx locktime. In the script it is
1 (interpreted as block height), but in the tx is 500000000
(interpreted as date)
* The stack is empty when executing OP_CLTV
* The tx is final by having only one input with MAX_INT sequence number
* The operand for CLTV is negative (after OP_0 OP_1 OP_SUB)
No longer relevant after #5957. This hack existed because of another
hack where the numthreads parameter, on regtest, doubled as how many
blocks to generate.
stephenhutchings commented 3 Jul 2015, 6:35 GMT:
> Hi Luke, happy for these to be distributed under the terms of the MIT licence.
> Let me know if you need anything further from me.
177a0e4 Adding CSubNet constructor over a single CNetAddr (Jonas Schnelli)
409bccf use CBanEntry as object container for banned nodes (Jonas Schnelli)
dfa174c CAddrDB/CBanDB: change filesize variables from int to uint64_t (Jonas Schnelli)
f581d3d banlist.dat: store banlist on disk (Jonas Schnelli)
CTransAction::IsEquivalentTo was introduced in #5881.
This functionality is only useful to the wallet, and should never have
been added to the primitive transaction type.
72b9452 When processing RPC commands during warmup phase, parse the request object before returning an error so that id value can be used in the response. (Forrest Voight)
request object before returning an error so that id value can
be used in the response.
Prior to this commit, RPC commands sent during Bitcoin's
warmup/startup phase were responded to with a JSON-RPC error
with an id of null, which violated the JSON-RPC 2.0 spec:
id: This member is REQUIRED. It MUST be the same as the value
of the id member in the Request Object. If there was an error
in detecting the id in the Request object (e.g. Parse
error/Invalid Request), it MUST be Null.
To determine the default for `-par`, the number of script verification
threads, use [boost:🧵:physical_concurrency()](http://www.boost.org/doc/libs/1_58_0/doc/html/thread/thread_management.html#thread.thread_management.thread.physical_concurrency)
which counts only physical cores, not virtual cores.
Virtual cores are roughly a set of cached registers to avoid context
switches while threading, they cannot actually perform work, so spawning
a verification thread for them could even reduce efficiency and will put
undue load on the system.
Should fix issue #6358, as well as some other reported system overload
issues, especially on Intel processors.
The function was only introduced in boost 1.56, so provide a utility
function `GetNumCores` to fall back for older Boost versions.
