This command allows a user to increase the fee on a wallet transaction T, creating a "bumper" transaction B.
T must signal that it is BIP-125 replaceable.
T's change output is decremented to pay the additional fee. (B will not add inputs to T.)
T cannot have any descendant transactions.
Once B bumps T, neither T nor B's outputs can be spent until either T or (more likely) B is mined.
Includes code by @jonasschnelli and @ryanofsky
On repeated calls to SelectCoins we try to meet the fee necessary for the last transaction, the new fee required might be smaller, so increase our change by the difference if we can.
Once we've picked coins and dummy-signed the transaction to calculate fee, if we don't have sufficient fee, then try to meet the fee by reducing change before resorting to picking new coins.
Performing signing in the inner loop has terrible performance
when many passes through are needed to complete the selection.
Signing before the algorithm is complete also gets in the way
of correctly setting the fee (e.g. preventing over-payment when
the fee required goes down on the final selection.)
Use of the dummy might overpay on the signatures by a couple bytes
in uncommon cases where the signatures' DER encoding is smaller
than the dummy: Who cares?
Fee estimation can just check its own mapMemPoolTxs to determine the same information. Note that now fee estimation for block processing must happen before those transactions are removed, but this shoudl be a speedup.
5394b39 Wallet: Split main logic from InitLoadWallet into CreateWalletFromFile (Luke Dashjr)
fb0c934 Wallet: Let the interval-flushing thread figure out the filename (Luke Dashjr)
cee1612 reduce number of lookups in TransactionWithinChainLimit (Gregory Sanders)
af9bedb Test for fix of txn chaining in wallet (Gregory Sanders)
5882c09 CreateTransaction: Don't return success with too-many-ancestor txn (Gregory Sanders)
0b2294a SelectCoinsMinConf: Prefer coins with fewer ancestors (Gregory Sanders)
This resolves an issue where a wallet transaction which failed to
relay previously because it couldn't make it into the mempool
will not try again until restart, even though mempool conditions
may have changed.
Abandoned and known-conflicted transactions are skipped.
Some concern was expressed that there may be users with many
unknown conflicts would waste a lot of CPU time trying to
add them to their memory pools over and over again. But I am
doubtful these users exist in any number, if they do exist
they have worse problems, and they can mitigate any performance
issue this might have by abandoning the transactions in question.
There are only a few uses of `insecure_random` outside the tests.
This PR replaces uses of insecure_random (and its accompanying global
state) in the core code with an FastRandomContext that is automatically
seeded on creation.
This is meant to be used for inner loops. The FastRandomContext
can be in the outer scope, or the class itself, then rand32() is used
inside the loop. Useful e.g. for pushing addresses in CNode or the fee
rounding, or randomization for coin selection.
As a context is created per purpose, thus it gets rid of
cross-thread unprotected shared usage of a single set of globals, this
should also get rid of the potential race conditions.
- I'd say TxMempool::check is not called enough to warrant using a special
fast random context, this is switched to GetRand() (open for
discussion...)
- The use of `insecure_rand` in ConnectThroughProxy has been replaced by
an atomic integer counter. The only goal here is to have a different
credentials pair for each connection to go on a different Tor circuit,
it does not need to be random nor unpredictable.
- To avoid having a FastRandomContext on every CNode, the context is
passed into PushAddress as appropriate.
There remains an insecure_random for test usage in `test_random.h`.
2ca6b9d Remove last reference to CWalletDB from accounting_tests.cpp (Patrick Strateman)
02e2a81 Remove pwalletdb parameter from CWallet::AddAccountingEntry (Patrick Strateman)
d2e678d Add CWallet::ReorderTransactions and use in accounting_tests.cpp (Patrick Strateman)
59adc86 Add CWallet::ListAccountCreditDebit (Patrick Strateman)
86726d8 Rename `-optintofullrbf` option to `-walletrbf` (Wladimir J. van der Laan)
05fa823 wallet: Add BIP125 comment for MAXINT-1/-2 behavior (Wladimir J. van der Laan)
152f45b Add option to opt into full-RBF when sending funds (Peter Todd)
Remove the unused variable "blockTmp" in CMerkleTx::SetMerkleBranch. It
was previously used to read the block from disk if not provided as
argument, but is no longer needed.
Forward-ports two commits from 0.13:
- [0.13] Create a new HD seed after encrypting the wallet
- [Wallet] Add CKeyMetadata record for HDMasterKey(s), factor out HD key generation
Github-Pull: #8389
Rebased-From: f142c11ac634df487cc4bc65a5f1c9a3e3563dd9 de45c065f0648c4c41b57cb492420ceeed29dd11
7945088 [Wallet] comsetic non-code changes for the HD feature (Jonas Schnelli)
68d7682 [Wallet] ensure CKeyMetadata.hdMasterKeyID will be cleared during SetNull() (Jonas Schnelli)
f708085 [QA] extend wallet-hd test to cover HD metadata (Jonas Schnelli)
986c223 [Wallet] print hd masterkeyid in getwalletinfo (Jonas Schnelli)
b1c7b24 [Wallet] report optional HDKeypath/HDMasterKeyId in validateaddress (Jonas Schnelli)
5b95dd2 [Wallet] extend CKeyMetadata with HD keypath (Jonas Schnelli)
This reverts PR #4906, "Coinselection prunes extraneous inputs from
ApproximateBestSubset".
Apparently the previous behavior of slightly over-estimating the set of
inputs was useful in cleaning up UTXOs.
See also #7664, #7657, as well as 2016-07-01 discussion on #bitcoin-core-dev IRC.
Move the version reporting to Wallet::Verify, before starting
verification of the wallet.
This removes the dependency of init on a specific wallet database
library.
A further, trivial step towards resolving #7965.
The "feefilter" p2p message is used to inform other nodes of your mempool min fee which is the feerate that any new transaction must meet to be accepted to your mempool. This will allow them to filter invs to you according to this feerate.
If number of conflict confirms cannot be determined, this means
that the block is still unknown or not yet part of the main chain,
for example during a reindex. Do nothing in that case,
instead of crash with an assertion.
Fixes#7234.
d11fc16 [Wallet] Call notification signal when a transaction is abandoned (Jonas Schnelli)
df0e222 Add RPC test for abandoned and conflicted transactions. (Alex Morcos)
01e06d1 Add new rpc call: abandontransaction (Alex Morcos)
9e69717 Make wallet descendant searching more efficient (Alex Morcos)
Unconfirmed transactions that are not in your mempool either due to eviction or other means may be unlikely to be mined. abandontransaction gives the wallet a way to no longer consider as spent the coins that are inputs to such a transaction. All dependent transactions in the wallet will also be marked as abandoned.
CWalletTx::GetAmounts could not find output address for null data transactions, thus issuing an error in debug.log. This change checks to see if the transaction is OP_RETURN before issuing error.
resolves#6142
A further pass over the available inputs has been added to ApproximateBestSubset after a candidate set has been found. It will prune any extraneous inputs in the selected subset, in order to decrease the number of input and the resulting change.
ff723da [Qt] improve minimum absolute fee option - Only display the minimum absolute fee control if CoinControl is enabled (Jonas Schnelli)
31b508a [Qt] make use of the nMinimumTotalFee (absolute) in coincontrols fee calculation (Jonas Schnelli)
80462dd [Qt] use ASYMP_UTF8 (≈) whenever we show a fee that is not absolute (Jonas Schnelli)
ecc7c82 Move fPayAtLeastCustomFee function to CC (Pieter Wuille)
This allows for much finer control of the transaction fees per kilobyte
as it prevent small transactions using a fee that is more appropriate
for one that is of a kilobyte.
This also allows controlling the fee per kilobyte over rpc such that:
bitcoin-cli settxfee `bitcoin-cli estimatefee 2`
would make sense, while currently it grossly fails often by a factor of x3
6342a48 Init: Use DEFAULT_TRANSACTION_MINFEE in help message (MarcoFalke)
a9c73a1 [wallet] Add comments for doxygen (MarcoFalke)
6b0e622 [wallet] Refactor to use new MIN_CHANGE (MarcoFalke)
* Introduce new constant MIN_CHANGE and use it instead of the
hardcoded "CENT"
* Add test case for MIN_CHANGE
* Introduce new constant for -mintxfee default:
DEFAULT_TRANSACTION_MINFEE = 1000
Assume that when a wallet transaction has a valid block hash and transaction position
in it, the transaction is actually there. We're already trusting wallet data in a
much more fundamental way anyway.
To prevent backward compatibility issues, a new record is used for storing the
block locator in the wallet. Old wallets will see a wallet file synchronized up
to the genesis block, and rescan automatically.
d042854 SQUASH "Implement watchonly support in fundrawtransaction" (Matt Corallo)
428a898 SQUASH "Add have-pubkey distinction to ISMINE flags" (Matt Corallo)
6bdb474 Implement watchonly support in fundrawtransaction (Matt Corallo)
f5813bd Add logic to track pubkeys as watch-only, not just scripts (Matt Corallo)
d3354c5 Add have-pubkey distinction to ISMINE flags (Matt Corallo)
5c17059 Update importaddress help to push its use to script-only (Matt Corallo)
a1d7df3 Add importpubkey method to import a watch-only pubkey (Matt Corallo)
907a425 Add p2sh option to importaddress to import redeemScripts (Matt Corallo)
983d2d9 Split up importaddress into helper functions (Matt Corallo)
cfc3dd3 Also remove pay-2-pubkey from watch when adding a priv key (Matt Corallo)
CTransAction::IsEquivalentTo was introduced in #5881.
This functionality is only useful to the wallet, and should never have
been added to the primitive transaction type.
Now that the off-by-one error w/nLockTime txs issue has been fixed by
87550eef (75a4d512 in the 0.11 branch) we can make the anti-fee-sniping
protection create transactions with nLockTime set such that they're only
valid in the next block, rather than an earlier block.
There was also a concern about poor propagation, however testing with
transactions with nLockTime = GetAdjustedTime()+1 as a proxy for
nLockTime propagation, as well as a few transactions sent the moment
blocks were received, has turned up no detectable issues with
propagation. If you have a block at a given height you certainly have at
least one peer with that block who will accept the transaction. That
peer will certainly have other peers who will accept it, and soon
essentially the whole network has the transaction. In particular, if a
node recives a transaction that it rejects due to the tx being
non-final, it will be accepted again later as it winds its way around
the network.
Previously due to an off-by-one error the wallet ignored
nLockTime-by-height transactions that would be valid in the next block
even though they are accepted into the mempool. The transactions
wouldn't show up until confirmed, nor would they be included in the
unconfirmed balance. Similar to the mempool behavior fix in 665bdd3b,
the wallet code was calling IsFinalTx() directly without taking into
account the fact that doing so tells you if the transaction could have
been mined in the *current* block, rather than the next block.
To fix this we strip IsFinalTx() of non-consensus-critical
functionality, removing the default arguments, and add CheckFinalTx() to
check if a transaction will be final in the next block.
a8cdaf5 checkpoints: move the checkpoints enable boolean into main (Cory Fields)
11982d3 checkpoints: Decouple checkpoints from Params (Cory Fields)
6996823 checkpoints: make checkpoints a member of CChainParams (Cory Fields)
9f13a10 checkpoints: store mapCheckpoints in CCheckpointData rather than a pointer (Cory Fields)
Compute the change directly as difference between the "requested" and
the actual value returned by SelectCoins. This removes a duplication of
the fee logic code.
It's reasonable that automatic coin selection will not pick a zero
value txout, but they're actually spendable; and you should know
if you have them. Listing also makes them available to tools like
dust-b-gone.
Define CTransaction::IsEquivalentTo(const CTransaction& tx)
True if only scriptSigs are different. In other words, true if
the two transactions are malleability clones. In other words,
true if the two transactions have the same effect on the
outside universe.
In the wallet, only SyncMetaData for equivalent transactions.
This is an advanced feature which will disable any kind of automatic
transaction broadcasting in the wallet. This gives the user full control
of how the transaction is sent.
For example they can broadcast new transactions through some other
mechanism themselves, after getting the transaction hex through `gettransaction`.
This just adds the option `-walletbroadcast=<0,1>`. Right now these
transactions will get the status
Status: conflicted, has not been successfully broadcast yet
They shouldn't be shown as conflicted at all (`walletconflicts` is empty). This status
will go away when the transaction is received through the network.
Adds a regression test for the wallet's ResendWalletTransactions function, which uses a new, hidden RPC command "resendwallettransactions."
I refactored main's Broadcast signal so it is passed the best-block time, which let me remove a global variable shared between main.cpp and the wallet (nTimeBestReceived).
I also manually tested the "rebroadcast unconfirmed every half hour or so" functionality by:
1. Running bitcoind -connect=0.0.0.0:8333
2. Creating a couple of send-to-self transactions
3. Connect to a peer using -addnode
4. Waited a while, monitoring debug.log, until I see:
```2015-03-23 18:48:10 ResendWalletTransactions: rebroadcast 2 unconfirmed transactions```
One last change: don't bother putting ResendWalletTransactions messages in debug.log unless unconfirmed transactions were actually rebroadcast.
During startup, when adding pending wallet transactions, which spend outputs of
other pending wallet transactions, back to the memory pool, and when they are
added out of order, it appears as if they are orphans with missing inputs.
Those transactions are then rejected and flagged as "conflicting" (= not in the
memory pool, not in the block chain).
To prevent this, transactions are explicitly sorted.
